30Ton Pneumatic-Hydraulic Shop PressBushing Press-Fit, 66,000LB Capacity + Gauge

The YD06-015 30TON Pneumatic/Hydraulic Shop Press is an industrial-grade equipment designed for high load-bearing capacity, flexibility, and precise pressure control. Ideal for mechanical maintenance and hardware processing, it combines pneumatic drive efficiency with hydraulic transmission stability.

• Structural Strength: Welded frame design with flaw detection testing increases load-bearing strength by 30%
• Operational Flexibility: Side-movable press head with full workbench adjustment range improves efficiency by 40%
• Pressure Control: Liquid-filled pressure gauge with ±1% accuracy prevents workpiece damage

• Auto Gearbox Maintenance: Gear replacement with 15-25 ton recommended pressure
• Bushing Press-Fitting: Precise installation for motors and reducers
• Agricultural Machinery: Drive axle bearing maintenance with 6.3" stroke
• Metal Shaping: Bending 30-50mm steel plates with consistent results

1. Clean guide rail and apply lithium-based grease
2. Check side-movement drive mechanism bolts (25-30N*m torque)
3. Verify pneumatic system pressure (0.6-0.8MPa)

1. Reduce equipment vibration with shock-absorbing pads
2. Vent air from liquid-filled pressure gauge
3. Replace gauge if deviation persists (0-40 ton range recommended)

1. Clean/replace air inlet filter
2. Check hydraulic oil level and quality (46# anti-wear recommended)
3. Inspect boosting valve for wear